3-in-1 Soil Tester | No Battery | pH, Moisture ...

No Battery 3-in-1 Soil Analyzer: Precision Monitoring for Perfect Growing Conditions Eliminate the guesswork. Monitor your soil’s health without batteries or complex calibration. The Eco Bini 3-in-1 Soil Tester is a rugged, analog diagnostic tool designed for the serious grower. By measuring the three most critical environmental factors—pH, Moisture, and Light—this device ensures your plants are always in their “Goldilocks zone” for maximum nutrient uptake. Key Technical Features: Dual-Probe Technology: Unlike single-probe units, our double-needle design uses the electrolytic properties of the soil to provide more stable and accurate readings for both pH and moisture levels. Battery-Free Operation: Powered entirely by the chemical reaction in the soil and the solar sensor. It is always ready to use and 100% eco-friendly. Triple-Function Interface: Moisture: Prevents overwatering and root rot pH: Ensures your soil is in the optimal 6.0–7.0 range for nutrient availability. Light: Helps you identify the best location for your hydroponic towers or garden beds. Laboratory Grade: Designed with a durable aluminium and copper probe set that resists corrosion and provides rapid feedback. How to Use the 3-in-1 Soil Tester Switch to Mode: Select moisture, pH, or light on the dial. Insert Probe: Push 10-13 cm into soil (moist soil for pH; near plant for light). Read Scale: Wait a few seconds for the pointer to stabilize: moisture (1–10: 1-3 dry, 4-7 normal, 8-10 wet), pH (3.5–8: 3.5-6.5 acid, 7-8 alkaline), light (0–2000 lux: 0-200 low, 200-500 low , 500-1000 normal, 1000-2000 high). Clean Probe: Wipe with water after use (no soap). Tips: Test multiple spots and average results. For pH, soil must be moist. No batteries needed — insert and read instantly. Avoid rocks/hard soil to prevent damage. STS Tech Note: We recommend this as an in-situ diagnostic tool for problem areas. A quick pH check often reveals “nutrient lockout” caused by imbalanced acidity. Maintenance for Longevity: > * Do Not Leave in Soil: The galvanic reaction that drives the probes is constant; leaving them in moist ground will cause the metal to oxidize (rust) prematurely. Always remove after use.